Close Loop

Closeloop settings
Disable Closeloop: Disables O2 Close Loop corrections
DIsable O2 Heater: Disables O2 Heater control

Settings:
O2 Input: Selects O2 Input signal Pin (Modifications might be needed)
Disable Above Load: Disables closed loop corrections above the specified load
Correction Trim: Percent of corrections added when closed loop is active
Target O2 voltage: O2 Voltage that the ECU will try to achieve when closed loop is active (actual AFR to Voltage Values are different between Lamda controllers)

Short/Long Term Correction
Short Term Trim Min/Max Adjustment: Minimum/Maximum adjustments allowed for the Short Term Trim
Long Term Trim Min/Max Adjustment: Minimum/Maximum adjustments allowed for the Long Term Trim

Dissable by TPS
RPM: RPM setpoints for the O2 Disable by TPS
Disable TPS: Percent (%) of TPS that the closed Loop will be disabled at the specified RPM
Enable TPS: Percent (%) of TPS that the closed Loop will be enabled at the specified RPM

Rate of Change -%/s
The rate of change in perecent per seconds of O2 corrections

Slow: Values for when the rate of change is slow
Fast-Rich to Lean: Values for when the rate of change is fast and going from reach to lean
Fast-Lean to Rich: Values for when the rate of change is fast and going from lean to reach