PWM Targets

Wastegate: pick for scaling the above example used ~1 psi steps to give you a scale from -16 to 11 psi ( range )

Then when you use boost by gear. Say you set 15psi it will look at the targets table and workout what duty cycle is needed to hit that. Using close loop boost control will make up for having values slightly off but they still need to be in the ball park.

next start adjusting duty cycle numbers until you hit that value this is some trial and error testing! becaus every setup, valve and turbo and wastegate is diffrent, try 5% steps.

ABOVE SCREENSHOT ALL DUTYCYCLES ARE SET TO 0 so go test and figure out your values that match the target PSI you are gunning for.